[. . . ] Adjust your PC resolution so that it is the same as the optimal resolution for this product. Introduction Front MENU button [MENU/ ] Opens the on-screen menu and exits from the menu. Customized Key You can customize key assignment for the Custom button according to your preferences. Note You can configure the Customized key for a required function via Setup > Customized Key. Volume button When OSD is not on the screen, push the button to adjust volume. [. . . ] Press `SOURCE/ ' button to have the monitor double-check the input signal source. Q: A: If the power is on, reboot the computer to see the initial screen (the login screen), which can be seen. If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card. (Refer to the Preset Timing Modes) If the initial screen (the login screen) does not appear, contact the Service Center or your dealer. Q: Can you see "Not Optimum Mode", "Recommended Mode 1440 x 900 60 Hz" on the screen? Troubleshooting A: A: A: You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can handle properly. Adjust the maximum resolution and frequency that the monitor can handle properly. If the display exceeds WSXGA or 75 Hz, a "Not Optimum Mode", "Recommended Mode 1440 x 900 60 Hz" message is displayed. If the display exceeds 85 Hz, the display will work properly but the "Not Optimum Mode", "Recommended Mode 1440 x 900 60 Hz" message appears for one minute and then disappears. (The message is displayed again if the system is rebooted. ) Q: A: A: A: Q: A: There is no image on the screen. Press a key on the keyboard to activate the monitor and restore the image on the screen. Then press any key on the keyboard again to activate the monitor and restore the image on the screen. If a copy of the program is already installed, remove it, reboot the computer, and then install the program again. You need to reboot the computer for it to operate normally after installing or removing the program. Note Visit the MagicTuneTM website and download the installation software for MagicTuneTM MAC. Check the following items if there is trouble with the monitor. Check if the power cord and the video cables are properly connected to the computer. (If it does, request an a service for the main board of the computer. ) If you installed a new video card or if you assembled the PC, check if the installed the adapter(video) driver and the monitor driver. Check if the scanning ratio of the video screen is set to between 56 Hz ~ 75 Hz. (Do not exceed 75 Hz when using the maximum resolution. ) If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter in the "Control Panel System Device Administrator" and then reboot the computer to reinstall the adapter (video) driver. Note If problems repeatedly occur, contact an authorized service center. {963UW} Q&A Q: A: A: How can I change the frequency?Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details. ) Troubleshooting Q: A: How can I adjusts the resolution?Windows XP: Set the resolution in the Control Panel Appearance and Themes Display Settings. A: Windows ME/2000: Set the resolution in the Control Panel Display Settings. [. . . ] (The maximum frequency per resolution may differ from product to product. ) There are only 16 colors shown on the screen. The screen colors have changed after changing the video card. Q: A: Have the Windows colors been set properly?Windows XP : Set the resolution at the Control Panel Appearance and Themes Display Settings. A: Windows ME/2000 : Set the resolution at the Control Panel Display Settings. [. . . ]